Programmed Digestion Furnace JRX-10L, 10 Positions (CAT#: STEM-AL2-4117-ZJF)

The JRX-10L programmed digestion furnace is a laboratory heating system for parallel sample digestion. It is intended for preparing samples before nitrogen analysis and other wet-chemical procedures. Digestion tubes are placed into dedicated heating positions within the heating block. The block transfers heat directly to the tubes to support consistent sample treatment. Electronic temperature regulation controls the heating process during digestion. The multi-position layout allows several samples to be processed in the same operating cycle. The instrument includes control and protection functions for routine laboratory heating. Its configuration supports standardized sample preparation before downstream analytical measurement.

Sample Positions: 10
Hole Diameter: Ø43.5 mm
Compatible Tube Diameters: Ø42 mm and Ø40 mm
Heating Block Material: Aluminum block
Design Temperature: 450°C
Temperature Accuracy: ±1°C
Heating Rate: Approx. 6-10°C/min
Control Display: 5-inch color touch screen
Control Mode: 1-40 segment programmed heating or single-point heating
Power Control: Segmented power control
Program Memory: 9 programs
Shutdown Timer: 1-999 min
Power Supply: AC 220 V, 50 Hz
Heating Power: 1.8 kW

Surface over-temperature sensor with alarm and shutdown
Fast-access graphical control interface
Visually separated function and application pages
Single-point and programmed heating modes
Segmented power control
Power-failure recovery function
Multi-position digestion block