Vitek 32 Microbial Identification/Susceptibility System, BioMerieux (CAT#: STEM-CTEPO-0135-ZJF)

The manufacturer of the Vitek 32 Microbial Identification/Susceptibility System, BioMerieux is BioMerieux.
Refurbished BioMerieux Vitek 32 microbial identification/susceptibility system. (Reader/Incubator, Filler/Sealer and CC4 available) The Vitek 32 analyzer automatically identifies the genus species of the bacterial present and the antibiotic sensitivity testing at the same time.
A primary source instrument for microbial identification, this instrument is a must have for any QC analytical laboratory involved in pharmaceutical development or manufacturing. Provides a cost effective primary ID analysis for all those environmental monitoring and cleaning validation studies.
The Bio Merieux Vitek Series corresponds perfectly to current bacteriological constraints, both in the clinical field and in industrial quality controls: automation provides more safety and eliminates repetitive manual operations, and the response time means that results can be provided more quickly than with manual techniques. The Vitek Series automates all the steps needed to perform identification Gram Negative and Gram Positive tests, using Vitek Cards. The filler/sealer enables inoculation of cards within a few minutes. The incubator/reader simultaneously incubates and reads the cards, and has a capacity of between 32 and 480 cards depending on the model. The optional computer software continuously monitors the operations under way, stores values, processes and interprets results.

Condition: Refurbished, Certified Pre-owned
VITEK 32 Filler General Characteristics
Ventilation: 4 in. on all sides
Filler cycle Time: < 4 min.
Capacity: 32 cards
Environmental Characteristics
installation Location: lndoor usage only. Do not install in direct sunlight.
VITEK 32 Reader/lncubator
General Characteristics
Dimensions: 23 in. high, 14.5 in. wide, 28.675 in. deep
Ventilation: 4 in. on all sides
Weight: 96 lb.
Handling: Two people, left and right side from bottom
Reader Cycle Time: 3 min./tray; <20 sec./card.
Capacity: Four trays, each holding up to eight cards
Detector: Phototransistor, with photometric drift below detection limits
lndex Control: Digital stepping motors
lncubator Control Temperature: 35°C ±2°CEnvironmental Characteristics
Installation Location: lndoor usage only. Do not install in direct sunlight.
Operating Temperature: 2O°C to 30°C, measured 1 in. from the unit cover.
Relative Humidity: 200/0 to B0o/o (non-condensing)
Pollution Degree: Degree 2 in accordance with IEC 60664
Overvoltage: Category ll Per IEC 60664
Electrical Characteristics
Powel cord: U.S.- and csA-recognized detachable three-wire with ground, pet IEC 60227 or
IEC 60245
lnput Voltage:
l00/l20 VAC at 50/60 Hz; 2.0 Amp (avd; 3.0Amp (Peak)
200/240 VAC at 50160 Hz; 1.0 AmP (av9; 1.5 AmP (Peak)
Maximum Current
3 AmP at 100/120VAC
l.5 Amp at 200/240 VAC
Power: 250 Watts
Heat: 734 BTU/Hr.
Fuse Current:
4-Amp Time-Delay 120 VAC
2.5-Amp Time-Delay 22O VAC
Data Port: RS-232 serial interface to computer

Refurbished to meet manufacturer's specification
In excellent condition
Thoroughly cleaned
Money back guarantee
Certified with warranty

Victor3 V Multilabel Counter, Perkin Elmer
YSI 2700 Select Biochemistry Analyzer, YSI
YSI 8500 CO2 Monitor, YSI