SY 60 mm Stroke Fast-Switching Syringe Pump (CAT#: STEM-AL-2616-ZJF)

This SY configuration is a programmable syringe-pump module for automated precision liquid transfer. It is operated by an external computer or microprocessor and can perform aspiration, dilution, movement, and dispensing functions. The module uses a 60 mm rated stroke with a controlled trapezoidal lead-screw drive. Its supported syringe range is intended for microliter-to-milliliter liquid handling. The listed motion range allows both slow metering and faster plunger travel. A rapid adjacent-port switching mechanism supports coordinated multi-position fluid routing. Borosilicate glass, PTFE, and alumina ceramic form the specified liquid-contact components. Serial and CAN control interfaces allow the pump to be incorporated into automated sample-introduction systems.

Liquid Accuracy: Error ≤1% at rated stroke
Liquid Precision: 0.3-0.5% repeatability error at rated stroke
Rated Stroke: 60 mm
Control Steps: 6000 steps
Linear Speed: 0.005-30 mm/s with purified water
Rated-Stroke Run Time: 2-12000 s with purified water
Control Resolution: 0.01 mm per step
Drive Structure: Trapezoidal lead screw with 2 mm lead
Compatible Syringe Volume: Optional 50 uL-10 mL
Wetted Materials: Alumina ceramic, borosilicate glass, and PTFE
Port Thread: 1/4-28 UNF female
Adjacent-Port Switching Time: ≤280 ms
Communication Interface: RS232, RS485, and CAN
Serial Communication Rate: 9600, 19200, 38400, 57600, or 115200 bps
CAN Communication Rate: 100, 200, or 500 kbps, or 1 Mbps
Control Protocol: ASCII, custom, and Modbus
Parameter Setting: Through communication interface
Power Supply: 24 VDC, 3 A
Operating Environment: 5-55 °C, below 80% RH, non-condensing
Weight: 2.023 kg

Programmable liquid-transfer module
Automated aspiration, dilution, and dispensing
Rapid adjacent-port switching
Broad syringe-volume compatibility
Lead-screw plunger actuation
External host control
Serial and CAN connectivity
Communication-based parameter setting