LH-DX01 Digital Suspended Solids Sensor, 0-3000 mg/L (CAT#: STEM-AL-3988-ZJF)

LH-DX01 Digital Suspended Solids Sensor is designed for continuous online measurement of suspended solids and turbidity. The sensing element converts the water-quality response into an electrical signal. Digital communication transfers measured values to a compatible controller or monitoring platform. The documented measurement range defines the intended analytical operating window. Integrated electronics support calibration data and configured operating parameters. The housing and sealing arrangement support immersion or flow-cell installation as specified. Temperature compensation or an integrated temperature element is used where documented. Low-power operation supports long-term monitoring installations. The sensor supports repeatable online measurement within the stated environmental limits.

Measured Parameter: suspended solids and turbidity
Measurement Range: 0-3000 mg/L
Operating Temperature: 5-40 °C
Maximum Immersion Depth: underwater5 m
Digital Interface: MODBUS/RS485
Analog Interface: 4-20mA
Power Supply: 12VDC±20%,1A
Calibration: one- or two-point calibration
Ingress Protection: IP68
Installation: flow-cell installation
Material: 316stainless steel
Dimensions: Φ54*150mm
Cable Length: 5 m(standard)

Supports continuous online measurement
Digital communication enables controller integration
Sealed construction supports water monitoring
Low-power electronics suit long-term deployment
Calibration parameters can be retained
Temperature compensation is available where configured
Multiple installation methods support process or environmental use