Cameo Plus Syringe Filter, 33mm, GVS (CAT#: STEM-ME-0144-ZLZ)

Increased throughput and speed of sample preparation.
Lower hold-up volume due to an improved flow channel design and reduced spacing between the supports within the housing for better handling of small sample volumes or costly samples.
Increased operating pressure up to 130 psi due to the over-mold that prevents sample leaking at the seam and keeps the filter unit from bursting in half.
Strict quality control: Syringe filters are integrity-tested to ensure a proper filter fit and weld to eliminate any potential filter by-pass.
Accurate labeling: Each filter is labeled with the specific filter material and pore size for easy identification even if the syringe filter is not in its original packaging.

Housing: Pure polypropylene is heat-sealed without the use of glues or sealants
Media: Nylon, PTFE, PES, PVDF, glass fiber, cellulose acetate and polypropylene
Autoclavable: Yes
Prefilter: 1.0 micron binderless glass-fiber
Filtration area: 4.8 cm2(0.74 inch3)
Housing diameter: 33mm
Membrane diameter: 30mm
Holdup volume: < 60 microliter
Sample volume: < 120 mL without prefilter
Inlet/outlet: FLL-MLS

Low hold-up volume to better handle small sample volumes or expensive samples;
Increase the working pressure to 130 psi;
The syringe filter must pass the integrity test;
Each filter is marked with a specific filter material and pore size for easy identification;