MJ Research PTC-100 Thermal Cycler, 45 in. x 30 in. x 39 in., Bio-Rad Laboratories, Inc. (CAT#: STEM-PEPO-0036-LGZ)

The MJ Research PTC-100 is a rugged thermal cycler that provides solutions for a variety of temperature configuration needs. The instrument is available in versions for use with 96- or 60-well microplates, as well as a heated lid for oil-free operation. Heated Valve Lids Heated lids mounted on each unit have a thumb wheel allowing easy adjustment of height and pressure. This modified property ensures a tight seal of the reaction vessel and microplate during oil-free thermal cycling.

The Precise Peltier-effect heat pumps of PTC-100 thermocyclers are engineered to withstand repeated cycles. Any temperature sequence can be cycled up to 10,000 times. The instrument's NIST-traceable calibration feature allows for indefinite storage of materials at any temperature. Therefore, the hatch rate is very accurate. This calibration function is also responsible for the cooling of the results after unsupervised operation.

Data storage is worry-free with the MJ Research PTC-100 thermal cycler. The internal memory stores approximately 320 programs and the circulator comes with 14 pre-programmed protocols. Any temperature sequence can be cycled up to 10,000 times. You can also specify a ramp rate that is less than the maximum value. Data that is not properly stored due to a power outage can be safely secured for up to 12 hours using the PTC-100's power failure protection feature.

Condition: certified pre-owned
Thermal range: 0–100°C electronically (with Peltier-effect heat pumps)
Accuracy: ±0.5°C of programmed target at 60°C
Thermal homogeneity: ±0.4°C well to well within 30 seconds of arrival at 60°C
16MS slide block: ±0.4°C within 30 seconds of arrival at 90°C
RAMPING RATE
60-well block: up to 1°C/sec
96-well: up to 1.2°C/sec
96AgV gold/silver block: up to 2.5°C/sec
16MS Slide Block: up to 0.5°C/sec
SAMPLE CAPACITY
Dimensions (H x W x D): 45 in. x 30 in. x 39 in.
60-well block: Sixty x 0.5ml tubes
96-well block, 96AgV gold/silver block: 96 x 0.2ml tubes or one 96-well plate
16MS Slide Block: Sixteen 25 x 75mm slides and 24 x 0.2ml tubes
Line voltage: 100–240VAC rms (no adjustment needed among voltages within these ranges)
Frequency: 350W maximum (momentary 4.5 A)
Fuses: Two 4A, 5 x 20mm (4 ampere)
Displays: One 2 x 16 LCD alphanumeric display
Ports: One 25-pin 8-bit parallel interface printer port

Hot Bonnet heated lid
NIST-traceable calibration
Produce highly accurate cultures
Parallel Printer Interface
Power failure protection
Equipped with peltier effect heat pump
14 pre-programmed protocols

Bio-Rad iCycler iQ Real Time PCR Thermal Cycler, Detection Range 515–700 nm, Bio-Rad Laboratories, Inc. (CAT#-STEM-PEPO-0017-LGZ)
Bio-Rad S1000 Thermal Cycler, Frequency 50–60 Hz, Bio-Rad Laboratories, Inc. (CAT#-STEM-PEPO-0018-LGZ)
BioRad DNA Engine Opticon 2 Real-Time Cycler, High Sample Capacity, Bio-Rad Laboratories, Inc. (CAT#-STEM-PEPO-0019-LGZ)
BioRad iCycler PCR Thermal Cycler System, Bio-Rad Laboratories, Inc. (CAT#-STEM-PEPO-0020-LGZ)
Eppendorf Mastercycler EP GRADIENT Thermal Cycler Series, Gradient Range 1° to 20°C, Eppendorf (CAT#-STEM-PEPO-0021-LGZ)
Eppendorf Mastercycler EP GRADIENT S Thermal Cycler Series, Gradient Range 1° to 24°C, Eppendorf (CAT#-STEM-PEPO-0022-LGZ)