Instek GPR3520HD In Lake Mary, FL, USA, GW Instek electrical test instruments (CAT#: STEM-GLEPO-1389-YJL)

Instek GPR3520HD In Lake Mary, FL, USA, model GPR3520HD is manufactured by GW Instek electrical test instruments.

Condition: Used
Constant Voltage Operation
Line Regulation: £0.01% +3mV
Load Regulation: £0.01% +5mV (rating current <10A)
£0.02% +5mV (rating current ³10A)
Ripple and Noise: £2mVrms 5Hz ~ 1MHz
Recovery Time: £100µs (50% load change, minimum load 0.5A)
Output Range: 0V to rated voltage, continuously adjustable
Constant Current Operation
Line Regulation: £0.2% +3mA
Load Regulation: £0.2% +3mA
Ripple Current: £5mArms (£20A), £20mArms (£50A), £100mArms (£100A)
Output Range: 0A to rated current, continuously adjustable
Meter
Meter Type: Dual 3½ digit 0.5" LED display
Accuracy: ±(0.5% of reading + 2 digits)
Insulation Chassis and Terminal: 100MW or above (1000V DC)
Chassis and AC Cord: 100MW or above (1000V DC)
Other Details
Power Source: AC 120V or 220V or 240V (specify when ordering) ±10%, 50/60Hz
Accessories: Power cord x 1, Instruction manual x 1, Test lead (type GTL-105 with units rated to 3A, type GTL-104 with units rated to 10A, not supplied with units rated over 10A) x 1
Dimensions: 430mm (w) x 178mm (h) x 572mm (d)
Weight: 30kg approx

Coarse and fine controls for voltage and current
3.5 digits, 0.5" LED voltage and current meters
Constant voltage, constant current with mode indicators
0.01% Regulation
Low ripple and noise (linear regulation)
Rear output terminal block with remote sensing on 240-375 W models
Overload and reverse polarity protection

Instek GPR25H30D In Lake Mary, FL, USA (CAT#: STEM-GLEPO-1390-YJL)
Instek GPS1850 In Lake Mary, FL, USA (CAT#: STEM-GLEPO-1391-YJL)
Instek GPR50H15D In Lake Mary, FL, USA (CAT#: STEM-GLEPO-1392-YJL)
Instek APS9301 In Lake Mary, FL, USA (CAT#: STEM-GLEPO-1393-YJL)
Instek APS9100 In Lake Mary, FL, USA (CAT#: STEM-GLEPO-1394-YJL)
Instek GPQ3020D In Lake Mary, FL, USA (CAT#: STEM-GLEPO-1397-YJL)