C-Type Weighing Plate, 20 t Standard Axle Load (CAT#: STEM-BC-3342-ZJF)

The C-Type Weighing Plate is intended for portable vehicle axle-load measurement. Its low-profile structure allows vehicles to pass over the sensing platform for weighing. The standard 900 × 500 × 39 mm version is rated for a 20 t axle load. A smaller 500 × 400 × 39 mm plate is specified for a 10 t axle load. Nominal output sensitivity is 1 ±0.2 mV/V. The IP66 enclosure protects the internal sensing components against dust and water. The plate can operate between -40°C and 80°C. Multiple stated load ratings support different vehicle and industrial weighing requirements.

Output sensitivity: 1 ±0.2 mV/V
Combined error: 0.1% F.S.
Nonlinearity: 0.1% F.S.
Repeatability: 0.1% F.S.
Input resistance: 120 ±10 Ω
Output resistance: 110 ±10 Ω
Insulation resistance: ≥5000 MΩ at 100 VDC
Zero output: 4-10% F.S.
Temperature effect on sensitivity: 0.1% F.S./10°C
Temperature effect on zero: 0.1% F.S./10°C
Compensated temperature range: -10°C to 50°C
Operating temperature range: -40°C to 80°C
Recommended excitation: 9-15 VDC
Maximum excitation: 20 VDC
Safe overload: 120% F.S.
Ultimate overload: 150% F.S.
Protection rating: IP66
Cable: Four-core shielded
Single-point maximum loads: 5, 10, 20, and 40 t
Maximum loads: 5, 10, 15, and 20 t
Plate sizes: 500 × 400 × 39 mm for 10 t axle load and 900 × 500 × 39 mm for 20 t axle load

Low-profile 39 mm design
20 t standard axle rating
Multiple load options
IP66 environmental sealing
-40°C to 80°C operation
Four-core shielded cable
150% ultimate overload
Portable axle measurement

STEM-BC-0445-ZJF
STEM-BC-0699-ZJF
STEM-BC-0700-ZJF
STEM-BC-0701-ZJF
STEM-BC-0702-ZJF