Bio-Rad Trans-Blot SD Cell In Woonsocket, RI, USA (CAT#: STEM-BEPO-0004-YJL)

Bio-Rad Trans-Blot SD Cell In Woonsocket, RI, USA, model Bio-Rad TRANS-BLOT SD CELL, is manufactured by Bio-Rad biotechnology & life science.
Used Bio-Rad Trans-Blot SD Cell Transfer Station for sale.
The Trans-Blot® SD semi-dry transfer cell allows fast, efficient, economical blotting without a buffer tank or gel cassettes.

Condition: Used
Thermal range: -5 to 105C. but no more than 30C below ambient temperature; (4 to 100C for the Slide Chambers Alpha unit)
Thermal accuracy: – or + 0.3C of programmed target at 90C- NIST-traceable
Thermal uniformity: – or + 0.4C well-to-well within 30 seconds of arrival at 90C; (for most Alpha units; see specifications for individual Alpha units)
Parallel: One 25-pin 8-bit parallel interface printer port
Serial: One 9-pin RS-232 serial port for printer or remote use
Ieee: One IEEE-488 bidirectional general purpose interface bus
Display: One 20 x 4 LCD alphanumeric display
W x l x h: 12 in. x 12 in. x 12 in.
Weight: 25lbs
Ramping speed: up to 3°C/sec in models that hold 0.2ml tubes or V-well plates
Capacity: Varies with installed Alpha unit
Temperature homogeneity: 0.4°C within 30 seconds of arrival @ 60°C for all standard models.
Line voltage: DNA Engine® cycler: 100–240 VAC rms; (no adjustment needed among voltages within these ranges)
Frequency: 50–60 Hz single phase
Power: DNA Engine cycler: 850 W maximum
Fuses: Two 6.3 A, 250 V, 5 x 20 mm
Accuracy: +0.3°C of programmed target at end columns,; 30 seconds after the timer starts for the; gradient step, NIST–traceable
Column uniformity: +0.4°C, well–to–well within column,; within 30 seconds of reaching target temperature
Gradient calculator accuracy: +0.4°C of actual well temperature
Lowest programmable temperature: 30°C
Highest programmable temperature: 105°C
Category: Thermal Cyclers in USA
Subcategory: Thermal cyclers (pcr)
Subcategory 2: Laboratory instrumentation
Listing ID: 39931908

Transfers take place in as little as 15–60 min
Minimal buffer requirements save money
Capacity to transfer up to four Mini-PROTEAN® precast or handcast gels, or three Criterion™ gels
Single-step locking system allows simple, speedy setup
Platinum-coated titanium anode plate electrodes and stainless-steel cathode plate electrodes provide consistent and reliable transfers, durability, and long life
Extra plastic templates required by other semi-dry blotters to prevent electrode short circuits are unnecessary
Safety cover breaks the electrical current when lifted, preventing electrical shock

2013 Bio-Rad Trans-Blot Turbo System Transfer System In White Marsh, MD, USA (CAT#: STEM-BEPO-0005-YJL)
Bio-Rad Gel Doc 2000 Gel Documentation System In Elkin, NC, USA (CAT#: STEM-BEPO-0006-YJL)
Biorad Model 785 In New Jersey, USA (CAT#: STEM-BEPO-0007-YJL)