A-Type Weighing Plate, 30 t Axle Load (CAT#: STEM-BC-3340-ZJF)

This A-type weighing plate is designed for measuring individual wheel or axle loads. Its standard plate measures 700 × 430 × 30 mm. The standard configuration is intended for axle loads up to 30 t. Available single-point maximum load ratings include 5, 10, 20, and 30 t. Available total maximum load ratings include 6, 12, 20, and 40 t. The sensor provides nominal output sensitivity of 1 ±0.2 mV/V. An IP66 protection rating supports operation in wet, dusty, and outdoor conditions. A four-core shielded cable carries the weighing signal while reducing electrical interference.

Output sensitivity: 1 ±0.2 mV/V
Combined error: 0.3-0.5% F.S.
Nonlinearity: 0.2% F.S.
Repeatability: 0.1% F.S.
Input resistance: 3120 ±40 Ω
Output resistance: 2800 ±10 Ω
Insulation resistance: ≥5000 MΩ at 100 VDC
Zero output: 4-10% F.S.
Temperature effect on sensitivity: 0.1% F.S./10°C
Temperature effect on zero: 0.1% F.S./10°C
Compensated temperature range: -10°C to 50°C
Operating temperature range: -40°C to 80°C
Recommended excitation: 9-15 VDC
Maximum excitation: 20 VDC
Safe overload: 120% F.S.
Ultimate overload: 150% F.S.
Protection rating: IP66
Cable: Four-core shielded
Single-point maximum loads: 5, 10, 20, and 30 t
Maximum loads: 6, 12, 20, and 40 t
Standard dimensions: 700 × 430 × 30 mm
Standard axle load: 30 t

30 t standard axle capacity
Low-profile 30 mm plate
IP66 environmental protection
Wide -40°C to 80°C range
Multiple load ratings
Shielded signal cable
150% ultimate overload
Portable axle weighing

STEM-BC-1003-ZJF
STEM-BC-1010-ZJF
STEM-BC-1023-ZJF
STEM-BC-1026-ZJF
STEM-BC-1076-ZJF